Daily maintenance of stainless steel kneading machine for structural adhesive equipment

The kneading machine for structural rubber equipment is an ideal equipment for kneading, mixing, vulcanizing rubber, and polymers with high viscosity and elastic-plastic materials. The kneading machine for structural adhesive equipment can be used to produce and manufacture silicone, sealants, hot melt adhesives, food adhesives, pharmaceutical and traditional Chinese medicine preparations, etc. The kneading machine for structural adhesive equipment is a unique mixing and blending device. It is common to use two ∑ blades and a parallel circular tangent differential type sorting, where one blade has a faster speed and the other has a slower speed, which is conducive to causing shear stress. Different blade speeds promote the rapid cutting of the mixed material, thereby enabling the material to be mixed evenly.

Maintenance and repair of key points inside the kneading machine:

1. After the installation of the kneading machine for structural adhesive equipment, cleaning, decontamination, and rust prevention treatment of vegetable oils and fats should be carried out from the beginning. Inspect each lubrication point and introduce lubricating grease (grease).

2. Before driving, check the tension level of the V-belt and adjust the anchor bolts to move the motor to an appropriate position.

3. Check if the standard components are loose, if the steam pipes are leaking, and if the power circuits and household appliances are safe. Electric heating kneading machine must have a grounding system

4. Before trial operation, clean and tidy the kneading machine room, perform 10-15 minutes of aviation parts rotation, and ensure that the equipment is running normally before investing in production and manufacturing. Generally, the transmission gear (including reducer) of a new mobile phone produces a lot of noise during the initial application, which naturally decreases during the waiting period.

5. When using steam heating, valves and pressure gauges should be installed at the inlet of the pipeline, and the working pressure of the steam should not exceed the professional knowledge of the mixing tank application working pressure specified on the label.

6. When mixing and kneading the slurry, it is necessary to reduce the use of flipping.

7. Oil should be dripped frequently at each lubrication location.

8. The sealing part of the board wall does not need to have any leakage of raw materials.

9. The tightness and looseness of the drive belt are suitable, and it should be regularly maintained, adjusted or replaced.

10. Steam pipelines are not allowed to leak. When the equipment is stopped, the gate valve should be closed and the reliability of the valve pressure gauge should be ensured.